English
- 9 -
(**)
Limited Models Only
3.9. Reset Apps
You can reset your customisations on the
Home
menu
to defaults using this
option (availability depends on
TV model and its features). Highlight and press
OK
.
A confirmation message will be displayed. Highlight
Yes
and press
OK
to proceed. Note that you will not
be able to perform this operation again within the next
few minutes.
3.10. Accessibility
You can access the accessibility settings menu directly
using this option.
3.11. Privacy Settings
You can access the privacy settings menu directly
using this option. This option may not be available
depending on the model of your TV and the selected
country during the first time installation process.
4. Settings
You can manage the settings of your TV using the
options of this menu. Refer to
Settings Menu Content
section for more information.
5.
Sources
You can manage your input source preferences using
the options of this menu. To change the current source
highlight one of the options and press
OK
.
5.1.
Source Settings
You can access the source settings menu directly using
this option. Edit the names, enable or disable selected
source options. There are also
Regular
and
Enhanced
options available for HDMI sources.
Regular
and
Enhanced
options are affecting the colour settings of
the selected HDMI source.
Inserting the Batteries into the Remote
Remove the back cover to reveal the battery compart-
ment. Insert two size
AAA
batteries. Make sure the (+)
and (-) signs match (observe correct polarity). Do not
mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on.
A message will be displayed on the screen when the
batteries are low and must be replaced. Note that when
the batteries are low, the performance of the remote
control may be impaired.
Batteries should not be exposed to excessive heat
such as sunshine, fire or the like.
Power Connection
IMPORTANT
: The TV set is designed to operate on a
220-240V AC, 50 Hz
supply. After unpacking, allow the
TV set to reach the ambient room temperature before
you connect the set to the mains. Plug the power cord
to the mains socket outlet.
Antenna Connection
Connect the aerial or cable TV plug to the aerial input
(ANT) socket located on the left side of the TV or
satellite plug to the satellite input (LNB) socket located
on the rear side of the TV.
Left side of the TV
1
1.
Aerial or cable
Rear side of the TV
2
2.
Satellite
If you want to connect a device to the TV, make
sure that both the TV and the device are turned off
before making any connection. After the connection
is done, you can turn on the units and use them.
