English
- 16 -
English
Initial Installation -
continued
You can select
Network
,
Frequency
,
Network
ID
and
Search
Step
from this screen. For
highlighting lines you see, use
Up
or
Down
button.
You can set
Search Step
as 8000 kHz or 1000
kHz. If you select 1000 kHz, the TV will perform
search process in a detailed way. Searching
duration will thus increase accordingly. When
finished, press
OK
button to start automatic
search.
If you select
NO
, the following screen will be
displayed:
You can set Start - Stop Frequencies and Search
Step as desired. When finished, press
OK
button
to start the search.
9.
If you select
Aerial
option from the Search Type
screen, the television will search for broadcasts.
10.
The Auto tuning screen will appear and the
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
Note
:
You can press
MENU
button to cancel.
11.
If you select
Satellite
option from the Search Type
screen,
Antenna Type
menu will be displayed.
There are three types of antenna selection. You
can select
Antenna type
as
Direct
,
Unicable
or
DiSEqC.
Direct:
If you have a single receiver and a direct
satellite dish, select this antenna type. After selecting
Direct
, another menu screen will be displayed.
Select an available satellite and press
OK
to scan
for services.
Unicable:
If you have multiple receivers and a
unicable system, select this antenna type. Press
OK
to continue. Configure settings by following
instructions on the screen. Press
OK
to scan for
services.
DiSEqC switch:
If you have multiple satellite
dishes and a
DiSEqC switch
, select this antenna
type. After selecting DiSEqC switch, another
menu screen will be displayed. You can set four
DiSEqC
options (if available). Press
GREEN
button to scan all satellites or press
YELLOW
button to scan only the highlighted satellite. To
save and exit press
OK
button.
SatcoDX Preset List:
When you start a search
a message will appear asking whether you want
to load preset list or not. This function is correct
for countries Germany and Austria. For other
countries select No and channel order will be
applied if applicable.
SartcoDX allows the user to upload a preset list
if supported by the broadcaster. See
Satellite
Settings
section.
