Toshiba 3000 series, Operation Manual

Page: 34 / 126

20
model 3000 Ethernet Module / DS Connection Module Operation Manual
Chapter 3 Setting
3
3.2 Network Parameter Setting
Set network parameters using the operation mode setting switches and host ID setting
switches.
For the switch setting procedures, refer to Table 3-1, Table 3-2 , Table 3-3 , and Table 3-
4.
Set the following network parameters on the EN7 module. Select only IP addresses of
class B only for the FN modules.
• IP address type
• Host ID
• Multicast address group
Be sure to set an IP address type and a host ID. Set a multicast address group in case of
using multicast transmission.
There are two IP address types, Class B (general) and TOSDIC-CIE 1200, in the EN7
module, but an arbitrary type can also be set using the Engineering Tool.
If controllers are dualized, register both parameters of primary and secondary controller
from configuration editor of engineering tool. Selection of primary and secondary is
performed on "comm. partner" of parameter setting window. (Refer to 3.2.4 Setting with
Engineering tool (4).)