Toshiba 29VH27D, Service Manual

Page: 6 / 158

1
1.INTRODUCTION
11AK52 is a 100Hz flicker free colour television capable of driving 28”4:3/16:9, 32” 16:9, 33”4:3 and
29”4:3 real flat picture tubes.
The chassis is capable of operation in PAL, SECAM, NTSC (playback) colour standards and multiple
transmission standards as B/G, D/K, I/I’, and L/L´.
Sound system output is supplying 2x10W (10%THD) for left and right outputs of 8ohm speakers.
TV supports the level 1.5 teletext standard. It is possible to decode transmissions including high
graphical data.
The chassis is equipped with two full EuroScarts, one SCART for AV input/output, one front-AV input,
one back-AV input, one headphone output, one SVHS input (via SCART and SVHS connector), two
external speaker outputs (left and right).
2.TUNER
The hardware and software of the TV is suitable for tuners, supplied by different companies, which are
selected from the Service Menu. These tuners can be combined VHF, UHF tuners suitable for CCIR
systems B/G, H, L, L´, I/I´, and D/K. The tuning is available through the digitally controlled I
2
C bus
(PLL). Below you will find info on one of the Tuners in use.
General description of UV1316:
The UV1316 tuner belongs to the UV 1300 family of tuners, which are designed to meet a wide range of
applications. It is a combined VHF, UHF tuner suitable for CCIR systems B/G, H, L, L’, I and I’. The low
IF output impedance has been designed for direct drive of a wide variety of SAW filters with sufficient
suppression of triple transient.
Features of UV1316:
1. Member of the UV1300 family small sized UHF/VHF tuners
2. Systems CCIR: B/G, H, L, L’, I and I’; OIRT: D/K
3. Digitally controlled (PLL) tuning via I
2
C-bus
4. Off-air channels, S-cable channels and Hyperband
5. World standardized mechanical dimensions and world standard pinning
6. Compact size
7. Complies to “CENELEC EN55020” and “EN55013”
Pinning:
1. Gain control voltage (AGC) : 4.0V, Max: 4.5V
2. Tuning voltage
3. I²C-bus address select : Max: 5.5V
4. I²C-bus serial clock : Min:-0.3V, Max: 5.5V
5. I²C-bus serial data : Min:-0.3V, Max: 5.5V
6. Not connected
7. PLL supply voltage : 5.0V, Min: 4.75V, Max: 5.5V
8. ADC input
9. Tuner supply voltage : 33V, Min: 30V, Max: 35V
10. Symmetrical IF output 1
11. Symmetrical IF output 2
3.IF PART (DRX 3960A)
Tuner output IF signal is pre-filtered with only one 8-MHz channel SAW filter. The entire multistandard
processing is performed. The Digital Receiver Front-end DRX 3960A performs the entire multi-standard
Quasi Split Sound (QSS) TV IF processing, AGC, video demodulation, and generation of the second
sound IF (SIF). Video and tuner AGC is controlled and adjusted by take over voltage. The alignment-
free DRX 3960A needs no special external components. All control functions and status registers are
accessible via I
2
C bus interface.