Torrey Pines Scientific, Inc.
9
VIII. SET UP PARAMETERS
SET UP PARAMETERS
1. Ambient operating room temperature range is from 5ºC to 40ºC.
2. Maximum altitude of operation should not exceed 2000 meters.
3. Maximum ambient operating relative humidity should not exceed 80% at 31ºC
decreasing linearly to 50% relative humidity at 40ºC.
SET UP INSTRUCTIONS
1. Place the unit securely on the surface.
2. Plug the power supply into a properly grounded, 3-wire outlet of proper voltage.
3. Plug the power supply cable into the jack on the chilling/heating module.
4. Place the sample block on the plate surface.
5. Connect the RS232 cable to the serial port on the computer. The LED on the inside
of the unit will illuminate and be blinking. The LED will stop blinking when the plate
temperature is within 1C of the Set Point temperature for 60secs.
Note: Do not use this equipment in any manner not specified by the
manufacturer.
ENVIRONMENTAL INFORMATION
1. This unit is for installation category II.
2. This unit is rated pollution degree 2.
