Torqeedo Cruise 10.0R, Translation Of The Original Operating Instructions

Page: 94 / 113

Error messages
DE EN
8 Error messages
Drive system
Display Cause Troubleshooting
E02 Stator excess temperature (motor overheated) After waiting for a short period (approx. 10 minutes), motor can be
operated slowly again.
Contact Torqeedo Service.
E05 Motor/propeller blocked Put the main switch into the "OFF" position, and disconnect the batteries.
Release the blockage, and turn the propeller one further turn by hand.
Reconnect the batteries to the system.
E06 Voltage to motor is too low Low state of charge of battery. It may be possible to restart the motor
slowly from the Stop position.
E07 Overcurrent to motor Continue at reduced power.
Contact Torqeedo Service.
E08 Circuit board excess temperature After waiting for a short period (approx. 10 minutes), motor can be
operated slowly again.
Contact Torqeedo Service.
E09 Water ingress to pylon Contact Torqeedo Service.
E21 Incorrect calibration of accelerator lever See accelerator lever manual.
E22 Magnetic sensor defective See accelerator lever manual.
E23 Value range incorrect See accelerator lever manual.
E30 Communication error with motor Check the plug connections of the data cables. Check the cables. If
necessary, contact Torqeedo Service and inform them of the error code.
E32 Communication error for accelerator lever Check the plug connections of the data cables.
Check the cables.
page 94 / 113