Operation
In order to use the display of the battery charge state display and the range
remaining, proceed as follows:
Before starting with a fully charged battery
1. Set the state of charge to 100 %, in accordance with the accelerator lever
manual.
ADVICE
Press the button only when the battery is fully charged. The on-board computer
calculates on the basis of the latest stored state of charge if the charge state is
not set to 100 %.The on-board computer calculates on the basis of the latest
stored charge state if the charge state is not set to 100 %.
6.3 Travel mode
6.3.1 Starting a trip
ADVICE
■
If there is visible damage to components or cables, the Cruise system must
not be switched on.
■
Ensure that all people on board wear a life jacket.
■
Before starting, attach the lanyard of the Emergency Stop to the skipper’s
wrist or life jacket.
■
The state of charge of the battery must be checked at intervals while on the
move.
ADVICE
During breaks in a trip, if there are swimmers near the boat while at anchor:
remove the Emergency Stop magnetic chip in order to avoid unintentionally
starting the Cruise system.
Starting the motor
1. Switch the motor on by pressing the On/Off button (1) for one second.
2. Place the Emergency Stop magnetic chip on the accelerator lever.
3. Move the accelerator lever from the neutral position to the desired position.
1
2
3
Fig. 51:
Throttle
page 89 / 113
