Toro Z597-D Z Master, Operator'S Manual

Page: 56 / 68

Figure 75
1. Measure here from blade
to hard surface
2. Measure at B and C
7. If the measurements at positions B or C are
not correct, loosen the bolt attaching the rear
chain to the rear support arm (Figure 76).
8. Loosen the jam nut under the rear support
arm and adjust the adjustment bolt to get
a measurement of 3-1/8 to 3-1/4 inches
(Figure 76).
Note:
It is recommended that both sides of
the mower are adjusted the same distance.
9. Tighten the jam nut under the rear support
arm and tighten the bolt securing the chain to
the rear support arm.
10. Adjust the opposite side if needed.
Figure 76
1. Rear chain 5. Adjustment bolt
2. Rear support arm 6. Front swivel
3. Bolt
7. Front support arm
4. Jam Nut
Adjusting the Front-to-Rear Mower
Pitch
1. Position the right blade front-to-rear
(Figure 77).
2. Measure the right blade at the A location, from
a level surface to the cutting edge of the blade
tip (Figure 77).
Figure 77
1. Measure here from blade
to hard surface
2. Measure at A and B
3. Record this measurement.
56