Figure 8
1.
Full down position
2.
Down position with bagger
installed
Important:
Ensure that the rear part of the
seat is secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter pins
and remove the two pins (Figure 9).
5. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 9).
Important:
Always use the seat belt with the
roll bar in the raised position.
G004955
1
2
3
4
Figure 9
1.
Roll bar
3.
Pin
2.
Raised position
4.
Hairpin cotter pin
Think Safety First
Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
DANGER
Operating on wet grass or steep slopes can cause
sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death or
drowning.
There is no rollover protection when the roll bar
is down.
Always keep the roll bar in the raised and locked
position and use the seat belt.
Read and follow the rollover protection instructions
and warnings.
To avoid loss of control and possibility of rollover:
•
Do not operate near drop-offs or near water.
•
Do not operate on slopes greater than
15 degrees.
•
Reduce speed and use extreme caution on
slopes.
•
Avoid sudden turns or rapid speed changes.
Figure 10
1.
Safe Zone-use the
Z Master here on slopes
less than 15 degrees or
flat areas.
3.
Water
2.
Use walk behind mower
and/or hand trimmer near
drop-offs and water.
18
