Toro Z Master Z597, Service Manual

Page: 99 / 198

5-12 Z Master Z597 Diesel Service Manual
5
ENGINE
Fig 261 DSC-2483
6. Before tightening the bolts and nuts on the engine
mounts, check the alignment of the engine drive
pulley to the right side pump pulley (Fig. 261). The
right and left engine mount brackets are slotted to
permit adjustment.
7. Tighten all three engine mount bolts and nuts once
alignment has been achieved.
Fig 260 engine mount assembly c
4. Install the right hand engine mount bolt. Note the
sequence of the washers from the bottom up: bolt,
large washer, and then the small thick washer
through the isolator; then a small washer and nut
(Fig. 260). Do not tighten the bolt and nut.
B
A
C
D
E F
A. Bolt D. Isolator
B. Large washer E. Small washer
C. Small thick washer F. Nut
5. Install the left hand engine mount bolt following the
same pattern as the right hand engine mount bolt.
Do not tighten the bolt and nut.