Drive System
Maintenance
Checking the Seat Belt
Service Interval:
Before each use or daily
Visually inspect seat belt for wear, cuts, and proper operation
of retractor and buckle. Replace before operating if damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval:
Before each use or daily
Check that both the mounting hardware and the knobs are
in good working condition. Make sure the knobs are fully
engaged with the ROPS in the fully raised position. The
upper hoop of the roll bar may need to be pushed forward or
pulled rearward to get both knobs fully engaged.
Figure 60
1.
ROPS knob (locked
position)
3.
Roll bar in the upright
position
2.
Pull ROPS knob out and
rotate 90 degrees to
change roll bar position
4.
Roll bar in the folded
position
Adjusting the Tracking
1.
Disengage the blade control switch (PTO).
2.
Drive to an open flat area, move the motion control
levers to the neutral locked position.
3.
Move the throttle midway between fast and slow.
4.
Move both motion control levers all the way forward
until they both hit the stops in the T-slot.
5.
Check which way the machine tracks.
6.
If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until the
machine tracks straight (Figure 61).
7.
If it tracks to the left, loosen the bolts and adjust the
right stop plate rearward on the right T-slot until the
machine tracks straight (Figure 61).
8.
Tighten the stop plate (Figure 61).
44
Summary of Contents for Z Master Professional 6000 Series
Page 11: ...109 7069 11...
