Toro Z Master Commercial TURBO FORCE 3000 Series, Operator'S Manual

Page: 46 / 72

Installing the Battery
Note:
Position the battery in the tray with the terminal
posts opposite from the hydraulic tank ( Figure 60 ).
g032526
Figure 61
Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30
A or 30 minutes at 10 A.
2. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (
Figure 62 ).
3. Install the battery in the machine and connect
the battery cables; refer to
Installing the Battery
(page 46) .
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
g000960
Figure 62
1. Positive battery post 3. Red (+) charger lead
2. Negative battery post 4. Black (-) charger lead
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on the console to the right
of the seat (
Figure 63 ).
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse ( Figure 63 ).
g008966
Figure 63
1. Optional accessory (15 A) 4. Main (25 A)
2. Charge (25 A) 5. Console
3. PTO (10 A)
46