Toro Z Master 74919TE, Operator'S Manual

Page: 54 / 80

B. Using needle-nose pliers, or by hand, hold
the tab and remove the shim (
Figure 75 ).
Note:
Do not discard the shim until proper
clutch function has been confirmed.
g010871
Figure 75
1. Shim
C. Using a pneumatic line, blow out any debris
from under the brake pole and around the
brake spacers.
D. Torque each bolt (M6 x 1) to 13 N∙m (10
ft-lb) +/-0.7 N∙m (0.5 ft-lb).
E. Using a 0.25 mm (0.01 inch) thick feeler
gauge, verify that a gap is present between
the rotor and the armature face on both
sides of the brake pole as shown in
Figure
76 and Figure 77 .
Note:
Due to the way the rotor and the
armature faces wear (peaks and valleys) it
is sometimes difficult to measure the gap
accurately.
g010872
Figure 76
1. Feeler gauge
g010873
Figure 77
1. Feeler gauge
•
If the gap is less than 0.25 mm (0.01
inch), then install the shim; refer to
Troubleshooting (page 74) .
•
If the gap is sufficient, proceed to the
safety check in step
F .
F. Perform the following safety check:
i. Sit on the seat and start the engine.
ii. Make sure that the blades do not
engage with the blade-control switch
(PTO) in the O
FF
position, and that
the clutch is disengaged.
If the clutch does not disengage,
install the shim again; refer to
Troubleshooting (page 74) .
iii. Engage and disengage the
blade-control switch (PTO) 10
consecutive times to ensure that the
clutch is functioning properly.
54