Removing the Sheet-Metal
Guard
Loosen the 2 front bolts and remove the sheet-metal
guard to access the mower belts and spindles
(
). After performing maintenance, install the
sheet-metal guard and tighten the bolts.
g027946
Figure 46
1.
Sheet-metal guard
2.
Bolt
Lubrication
Grease more frequently when operating conditions
are extremely dusty or sandy.
Grease Type:
No. 2 general-purpose lithium-based
or molybdenum-based grease
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-
LOCK
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean the grease fittings with a rag.
Note:
Make sure that you scrape any paint off
the front of the fitting(s).
4.
Connect a grease gun to the fitting.
5.
Pump grease into the fittings until grease begins
to ooze out of the bearings.
6.
Wipe up any excess grease.
Adding Light Oil or Spray
Lubrication
Service Interval:
Every 100 hours
Lubricate the deck-lift pivots.
g017028
Figure 47
39
Summary of Contents for Z Master 74919TE
Page 76: ...Schematics g009180 Wire Diagram Rev A 76 ...
Page 77: ...Notes ...
Page 78: ...Notes ...
