Toro Workman 133-3016, Installation Instructions Manual

Page: 2 / 8

1
Preparing the Machine
No Parts Required
For Gasoline GTX Vehicles
1. Park the machine on a level surface, set the
parking brake, shut off the engine, and remove
the key.
2. Disconnect the negative-battery cable; refer to
your
Operator’s Manual .
For Electric GTX Vehicles
1. Park the machine on a level surface, set the
parking brake, shut off the machine, and remove
the key.
2. Disconnect the main negative-battery cable
(black) that connects the bank of batteries to
the ground point of the machine; refer to your
Operator’s Manual .
2
Installing and Connecting
the Horn
Parts needed for this procedure:
1 12 V horn assembly (for Gasoline GTX vehicles)
1 48 V horn assembly (for Electric GTX vehicles)
1 Hex-head screw (5/16 x 3/4 inch)
1 Flange nut (5/16 inch)
For Gasoline GTX Vehicles
1. Release the rubber straps on both sides of the
hood and raise the hood.
2. Install the 12 V horn assembly to the existing
hole in the dash bracket with the hex-head
screw (5/16 x 3/4 inch) and flange nut (5/16
inch) as shown in
Figure 1 .
g034598
Figure 1
1. Dash bracket 3. Flange nut (5/16 inch)
2. Hex-head screw (5/16 x
3/4 inch) 4. 12 V horn assembly
3. Plug the 2 female connectors from the main wire
harness into the 2 male connectors on the 12
V horn (
Figure 2 ).
g034659
Figure 2
1. Female connector 2. Male connector
2