Assembly
11
Removing the Snowthrower
Note:
Save all hardware, washers and hairpin
cotters for reuse when installing
snowthrower.
1.
Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to “OFF” to stop the
engine. Remove the key.
2.
Remove hairpin cotter at U-joint and slide crank
handle out of support (Fig. 20).
1292
2
1
4
3
Figure 20
1.
Crank handle
2.
Support
3.
U-joint
4.
Hairpin cotter
3.
Unlatch and remove locking clevis pin and
handle support from frame (Fig. 21).
m–2819
2
1
3
Figure 21
1.
Handle support
2.
Pin
3.
Locking clevis pin
4.
Remove hairpin cotters, washers and belt cover
from belt guard bracket (Fig. 22),
m–2591
1
2
3 & 4
5
Figure 22
1.
Belt cover
2.
Belt guard bracket
3.
Washer and hairpin cotter
4.
Single cylinder holes
5.
Twin cylinder holes
