Toro Wheel Horse 12-32, Operator'S Manual

Page: 16 / 52

Assembly
14
4. Using left front spacer stud, loosely secure wire
clamp and seat to seat base with a locknut
(Fig. 3).
1
2
3
4
5
6
7
Figure 3
1. Seat spacers
2. Wire clamp
3. Seat switch wire
4. Locknut
5. Seat switch slot
6. Seat switch connector
7. Wire tie
5. Mount seat to seat base with (3) remaining
locknuts.
Note: Seat may be adjusted for operator
comfort by positioning seat as desired
in seat base slots.
6. Tighten all locknuts.
7. Insert seat switch connector into wire harness
connector.
8. Secure wire harness to front of seat base with
wire tie.
Activate the Battery
The battery must be removed from the machine so it
can be filled with electrolyte and charged. Remove
the battery and activate it as follows:
1. Tip seat forward exposing battery.
2. Remove wing nut securing battery hold downs to
rider chassis (Fig.4).
1
2
3
Figure 4
1. Wing nut
2. Battery hold–down
3. Filler cap
3. Lift up on top battery hold down and pivot
rearward
4. Remove battery from chassis and set it aside.
5. Remove filler caps from battery and slowly fill
each cell until electrolyte is just above the
“LOWER” fill line.
6. Leave filler caps off and connect a 3-4 amp
battery charger to battery posts. Charge battery at
a rate of 4 amperes or less for 4 hours (12 volt).
POTENTIAL HAZARD
•
Charging battery produces gasses.
WHAT CAN HAPPEN
•
Battery gasses can explode.
HOW TO AVOID THE HAZARD
•
Keep cigarettes, sparks and flames away
from battery.
7. When battery is charged, disconnect charger
from electrical outlet and battery posts.