Maintenance
41
5.
Install new deck belt if needed.
6.
Replace belt guides for transaxle pulley. Install
belt retainer on idler pulley and tighten locknut.
5
4
2
5
7
1
4
6
3
Figure 35
1.
Engine pulley
2.
Transaxle pulley
3.
Idler pulley
4.
Transaxle pulley belt
guides
5.
Engine pulley belt guides
6.
Belt retainer and locknut
7.
Drive belt
IMPORTANT: Idler retainer must be
installed at an 80 to 90 degree angle to the
idler mounting bracket (Fig. 36) or rider may
creep with clutch pushed down.
_
2
1
Figure 36
1.
Idler pulley
2.
Idler mounting bracket
7.
Install cutting unit: refer to Removing/lnstalling
Cutting Unit, page 39.
Leveling Cutting Unit
If mower doesn’t cut level from side–to–side and
cutting blade is not bent, level the cutting unit as
follows:
1.
Place rider on level surface, lock parking brake,
shut off engine and remove key from ignition
switch.
2.
Raise seat or remove left side panel from rider.
3.
Place height-of-cut lever in number 3 position
and position cutter blade at a right angle to
direction of rider travel.
4.
Measure the blade tip height at one end of blade,
rotate blade 180 degrees and measure same blade
tip at opposite side of rider. Measurement should
be within 1/8 inch (3 mm) of one another.
5.
If blade tip height is not within 1/8 inch (3 mm),
level cutting unit by loosening height-of-cut
support bracket capscrews and raising or
lowering the bracket (Fig. 37).
6.
Ensure blade tip height is within 1/8 inch (3
mm) and retighten capscrews.
Summary of Contents for Wheel Horse 12-32
Page 7: ...Safety 5 Slope Chart Read all safety instructions on pages 2 4 ...
Page 8: ...6 ...
Page 51: ......
Page 52: ......