47
8. Squeeze the element to remove
excess oil.
9. Clean any dirt or debris from inside
the filter housing.
10. Install the air filter and metal hold-
down, secure with the two knobs
tightened to 16 N-m (12 ft-lb), and
install the cover. Secure with the four
clips.
11. Lower the cargo box.
Air Filter Housing
Drains
TC033A
TC034A
Inspect and squeeze the “duck bill” drain
beneath the main housing for debris and
for proper sealing.
Remove the tube drain and clean out any
water, oil, or debris. Reinstall and secure
with the clamp.
Draining V-Belt Cover
NOTE: If the vehicle has been
driven through water, the V-belt
cover must be drained of any water.
1. Place the vehicle on a level surface.
2. From the right-rear of the vehicle,
remove the drain bolt from the cover
and allow the water to drain out.
TC025A
3. Move the shift lever to the neutral
position; then start the engine.
4. Increase and decrease engine RPM
several times to “blow out” any
water; then stop the engine.
5. Install the drain bolt and tighten
securely.
NOTE: The V-belt and pulleys
should be inspected every 500 miles
and the belt replaced (if necessary).
Tires
CAUTION
A torn air filter can cause damage to
the engine. Dirt and dust may get
inside the engine if the element is
torn. Carefully examine the element
for tears before and after cleaning it.
Replace the element with a new one if
it is torn.
500
700
CAUTION
Do not attempt to clear water with the
vehicle in park. The transmission is
locked and belt or clutch damage could
occur.
! WARNING
Always use the size and type of tires
as specified. Refer to the specifica-
tions chart for proper tire inflation
pressure, and always maintain proper
tire inflation pressure.
