Toro TurfMaster HDX, Operator'S Manual

Page: 31 / 40

g208923
Figure 44
1. Mark the cable here
g208920
Figure 45
1. Slack—11 mm (7/16 inch)
8. Torque the cable-clamp screw to 11 to 14 N∙m
(99 to 121 in-lb) to lock the adjustment in place.
9. Install the belt cover with the 4 bolts that you
removed in step
3 .
10. Connect the wire to the spark plug.
11. Check the operation of the blade-brake clutch.
Changing the Transmission
Belt
Service Interval: Every 250 hours
Removing the Transmission Belt
Note:
Retain all hardware removed in this procedure,
except the old transmission belt, for installation in
Installing the Transmission Belt (page 32) .
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Remove the 4 bolts that hold the belt cover to
the machine housing.
4. Remove the belt cover.
5. Remove any debris from under the belt cover.
6. If the grass bag is on the machine, remove it.
Refer to
Removing the Grass Bag (page 17) .
7. Raise and hold up the rear deflector.
8. Remove the rear-viewing window, located under
the rear-discharge deflector, by removing the
bolt holding it in place (
Figure 46 ).
g280620
Figure 46
1. Rear-viewing window 2. Rear-viewing-window bolt
9. Remove the dust shield by removing the 2 bolts
holding it in place (
Figure 47 ).
g280624
Figure 47
1. Trailing shield 2. Trailing-shield bolts
31