Toro TurfMaster HDX, Operator'S Manual

Page: 30 / 40

g208922
Figure 41
1. BBC belt 2. BBC belt guard
8. Remove the BBC belt from the brake-drum
pulley and then remove the belt from the
machine.
Note:
Hold one of the blades using a glove or
a rag and turn the blade spindle to help remove
the BBC belt.
9. To install a new BBC belt, reverse the steps
above.
10. Adjust the BBC cable; refer to Adjusting the
Blade-Brake Cable (page 30) .
Adjusting the Blade-Brake
Cable
Adjust the blade-brake cable whenever you install a
new cable or replace the BBC belt.
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Remove the belt cover ( Figure 6 ) by removing
the 4 bolts that hold it to the machine housing.
Note:
Save the bolts for installing the belt cover
to the machine housing.
4. Remove any debris from under the belt cover.
5. Loosen the cable-clamp screw ( Figure 42 ).
g208921
Figure 42
1. Cable-clamp screw 2. Blade-brake cable
6. Pull the cable jacket to remove slack ( Figure 43 ).
Note:
Do not put tension on the spring.
g208926
Figure 43
1. Cable clamp 2. Spring
7. Mark the brake cable ( Figure 44 ), then adjust
the jacket until there is approximately 11 mm
(7/16 inch) of slack (
Figure 45 ).
30