g014668
Figure 8
High hitch position
Mounting the Greensmower
Wheel Assemblies
Models 04244 and 04247 only
Note:
On Greensmaster 1000, 1010, and 2000
machines equipped with a groomer, remove the wheel
shaft on the groomer end and purchase and install a
new wheel shaft (Part No. 106-5385). Also, mount the
rail assembly on the groomer end to the Greensmaster
1600 and 1610 hole locations (
Note:
On Greensmaster 1800, 1820, 2100, and 2120
machines equipped with a groomer, remove the wheel
shaft on the groomer end and purchase and install a
new wheel shaft (Part No. 136-7287).
1.
Remove the existing standard transport wheels
from the wheel shafts on the greensmower (if
equipped).
2.
On Greensmaster Flex 18 or 21 machines only,
proceed as follows:
A.
Remove the right side drum cover from the
machine (
g017122
Figure 9
1.
Right side drum drive
cover
3.
Rubber grommet
2.
Felt seal
B.
Remove and discard the rubber grommet
from the axle hole in the drum cover (
).
C.
Affix the felt seal to the inside of the cover
positioning it around the axle hole (
).
D.
Install the cover to the machine.
3.
Insert a wheel onto each shaft and secure with a
wheel clip (
Note:
Flex 1800, 1820, and 2100, 2120 series
machines require a different wheel offset than
all other Toro greensmowers. Read and follow
the mounting instructions molded into the sides
of the wheels.
g014669
Figure 10
Left side shown
1.
Wheel shaft
3.
Wheel clip
2.
Wheel
5