Install the fasteners into the same holes in the deck they
were originally removed from. This ensure no holes are
left open when the deck is operated.
Open holes in the mower expose you and others
to thrown debris. Debris thrown out of holes in
the mower can cause injury.
•
Never operate the mower without hardware
mounted in all holes in the mower.
•
Install hardware in mounting holes when
the baffle is removed.
Removing the Mulch Baffle
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to park
position, stop the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the mower as described in the Removing
the Mower procedure in the
Maintenance
section for
more information.
4. Turn the mower upside down.
5. Remove the existing mower blades installed on your
deck. Refer to the Removing the Blades procedure
in the
Maintenance
section for more information.
6. Remove the three lock nuts (5/16 inch) secured to
the welded posts of the left baffle on the top of
the mower deck at the center, left of center and
left positions (Figure 31). Remove the carriage bolt
and lock nut on the side wall of the mower deck
securing the left baffle to the deck.
G01
1149
1
1
2
3
4
Figure 31
1.
Lock nut (5/16 inch)
3.
Left baffle
2.
Carriage bolt (5/16 x 3/4
inch)
4.
Install fasteners here
7. Remove the left baffle from the mower deck as
shown in Figure 31.
8. Locate the two bolts and lock nuts in loose
parts. Install these fasteners into the holes shown
inFigure 31 on the mower deck to prevent flying
debris. Install the bolt up, through the underside
of the deck and use a lock nut to secure from the
topside.
Open holes in the mower expose you and others
to thrown debris which can cause severe injury.
•
Never operate the mower without hardware
mounted in all holes in the mower housing.
•
Install the hardware in the mounting holes
when you remove the mulching baffle.
9. Remove the carriage bolt (5/16 x 3/4 inch) and lock
nut (5/16 inch) on the rear wall of the mower deck
securing the baffle to the deck (Figure 32).
G010712
1
2
4
3
5
6
7
Figure 32
1.
Carriage bolt (5/16 x 3/4
inch)
5.
Hex head bolt, forward
hole in deck (reinstall after
baffle is removed)
2.
Lock nuts, front of
discharge plate (reinstall
after baffle is removed)
6.
Carriage bolts, front of
discharge plate (reinstall
after baffle is removed)
3.
Lock nut, forward hole in
deck (reinstall after baffle
is removed)
7.
Lock nut (5/16 inch)
4.
Baffle guard, 54 inch
decks
10. Locate the baffle guard at the front edge of the side
discharge opening. Remove the fasteners securing
the baffle guard and the right baffle to the mower
25
Summary of Contents for TITAN ZX 5400
Page 6: ...Slope Chart 6...
Page 10: ...115 9628 1 Fuel 2 Full 3 Half 4 Empty 10...
