Toro TITAN ZX 5400, Operator'S Manual

Page: 22 / 56

G010236
1
2
3
4
5
Figure 24
1. Deck lift pedal
4. Lock position. lowest
height-of-cut (use only for
deck removal)
2. Cut height pin 5. Lock position. transport
position
3. Height-of-cut positions
Using the Lock Positions
The deck can be locked in the highest height-of-cut or
transport position or the lowest height-of-cut position.
1. Push on the deck lift pedal with your foot and raise
the mower deck to the transport position (also
the 4.5 inch (114 mm) cutting height position)
(Figure 24).
2. Remove the pin from the height-of-cut bracket
(Figure 24).
3. Select a hole on the lock decal and insert the pin
(Figure 24).
4. Push on the deck lift pedal with your foot and raise
the height-of-cut lever slightly to disengage the
transport lock. Lower the deck to slowly until the
pin makes contact with the lever.
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade control switch (PTO), move
the motion control levers to the neutral lock
position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
G010233
1
2
3
4
Figure 25
1. Anti-scalp roller 3. Flange Nut
2. Bolt 4. Hole spacing
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
While sitting in the operator’s position, raise the seat
adjustment lever slightly and move the seat forward or
backward to the desired position (Figure 26).
G010016
G010232
1
Figure 26
1. Adjustment lever
22