Toro TITAN 74891, Operator'S Manual, Page: 31 / 56

3. Remove the foam and paper elements ( Figure 35 ).
4. Remove the foam element from the paper element
(
Figure 35 ).
Figure 35
1. Air-cleaner cover 3. Paper element
2. Foam element
Servicing the Foam Element
1. Wash the foam element in warm water and detergent.
2. Rinse and allow it to air dry.
3. Lightly oil the foam element with new oil and squeeze
out excess oil.
Servicing the Paper Element
1. Gently tap the paper element to dislodge dirt.
Note:
Do not wash the paper element or use
pressurized air, as this will damage the element.
Note:
Replace a dirty, bent, or damaged element.
Handle the new element carefully; do not use if the
sealing surfaces are bent or damaged.
2. Clean the air-cleaner base as required, and check the
condition.
Installing the Elements
1. Install the foam element onto the paper element.
2. Install the elements onto the air-cleaner base ( Figure
35 ).
3. Install the cover, and secure it with the latches ( Figure
34 ).
Servicing the Engine Oil
Oil Type: Detergent oil (API service SJ or higher)
Crankcase Capacity: 1.9 L (64 oz) when the filter is changed
Viscosity: See the table below.
g017552
0
0
50
SAE 30
Figure 36
Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check the
engine-oil level.
1. Park the machine on a level surface, disengage the
blade-control switch, shut off the engine, and remove
the key.
2. Make sure that the engine is stopped, level, and is cool,
so the oil has time to drain into the sump.
3. Check the engine-oil level ( Figure 37 ).
B
A
C
D E
g027515
F
G H
Figure 37
31