6. Attach the adjusting rod to the machine with the
washer and hairpin cotter (Figure 59) on each side
of the mower.
7. Slide the leveling brackets onto the mounting pins
and secure them with the washers and hairpin cotters
(Figure 59).
8. Attach the front support rods to the machine with
the clevis pins and hairpin cotters (Figure 58).
9. Install the mower belt onto the engine pulley; refer
to Replacing the Mower Belt.
Cleaning
Cleaning the Collection
Sensors
Service Interval:
Before each use or daily
The collection sensors do not require any scheduled
maintenance, however; in the event that the collection
bag alarm goes off and the bag is less than full, gently
wipe off the faces of the sensors with a soft cloth. The
cloth can be damp with water.
Important:
Do not use solvents or chemicals of
any kind to clean the face of the sensors.
When finished using the machine, use a soft cloth to
clear away blockage between the sensors (crusted or
clumped up grass clippings or leaves).
Washing the Underside of the
Mower
Service Interval:
Before each use or daily
After each use, wash the underside of the mower to
prevent grass buildup for improved mulch action and
clipping dispersal.
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers to the brake position,
stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Attach the hose to the end of the mower washout
fitting, and turn the water on high (Figure 61).
Note:
Spread petroleum jelly on the washout fitting
O-ring to make the hose slide on easier and protect
the O-ring.
40
Summary of Contents for TimeCutter ZD420T
Page 45: ...Schematics G005894 Electrical Diagram Rev A 45 ...
Page 46: ...Notes 46 ...
