Toro TimeCutter ZD420T, Operator'S Manual

Page: 22 / 48

Adjusting the Motion Control
Levers
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 22).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 22).
Figure 22
1. Control lever 3. Control arm shaft
2. Bolt
3. Repeat the adjustment for the opposite control
lever.
Pushing the Machine by Hand
Important:
Always push the machine by hand.
Never tow the machine because damage may
occur.
To Push the Machine
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to engage
the parking brake, stop the engine, remove the key,
and wait for all moving parts to stop before leaving
the operating position.
3. Move the two bypass levers to the inside and push
them in until the washer on the rod passes through
the slot (Figure 23).
4. Push the levers outward to lock them in place
Figure 23.
5. Move the motion control levers inward to disengage
the parking brake.
The machine is now able to be pushed by hand.
Figure 23
1. Bypass lever, lever
position for pushing the
machine 2. Lever position for
operating the machine
To Operate the Machine
Move each bypass levers to the inside and pull them
rearward, completely through the slot (Figure 23). Push
the levers outward to lock them in place
Note:
The machine will not drive unless the bypass
levers are disengaged.
Adjusting the Footrest
The footrest can be adjusted forward or backward for
maximum operator comfort.
Lift up the footrest and place the rods in the same hole
positions (Figure 24).
Figure 24
1. Footrest 3. Hole positions
2. Rod
22