To turn, release the pressure on the motion control
lever toward the direction you want to turn.
To stop, push the motion control levers to neutral.
Stopping the Machine
To stop the machine, move the motion control levers to
neutral and outward to the park position, disengage the
blade control switch, ensure the throttle is in the fast
position, and turn the ignition key to off. Remember to
remove the key from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion control levers outward to the park position
when leaving the machine unattended, even if just
for a few minutes.
Adjusting the Height of Cut
1. Raise the height-of-cut lever to the transport
position, cutting height position
G
(also the
4-1/2 inch [115 mm]) (Figure 19).
G009619
1
2
3
4
5
6
7
8
Figure 19
1.
Height-of-cut lever
5.
3 inch (76 mm)
2.
4.5 inch (115 mm),
Transport position
6.
2.5 inch (64 mm)
3.
4 inch (102 mm)
7.
2 inch (51 mm)
4.
3.5 inch (89 mm)
8.
1.5 inch (38 mm)
2. To adjust the height of cut, pull inward and up on
the lever and move it to the desired position.
Using the Foot Assist Pedal
The foot assist pedal can be used with the height of cut
lever to help adjust the deck height.
1. Enter the operator’s position. Place a foot on the
foot assist pedal and apply pressure.
2. While maintaining pressure on the pedal, pull
inward and up on the height-of-cut lever and move
it to the desired position.
Figure 20
19
Summary of Contents for TimeCutter Z5035
Page 44: ...Schematics G009744 Electrical Diagram Rev A 44 ...
Page 45: ...Notes 45 ...
Page 46: ...Notes 46 ...
