Leveling the Mower Deck
Check to ensure the mower deck is level any time you
install the mower or when you see an uneven cut on
your lawn.
The mower deck must be checked for bent blades
prior to leveling; any bent blades must be removed
and replaced. Refer to the Checking for Bent Blades
procedure before continuing.
The mower deck must be leveled side-to-side first then
the front to rear slope can be adjusted.
Requirements:
•
The machine must be on a level surface.
•
All four tire must be properly inflated. Refer to
Checking the Tire Pressure in the Drive System
Maintenance section.
Side-to-Side Leveling
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Set the height-of-cut lever to middle position.
4. Carefully rotate the blades so that they are all side
to side (Figure 51).
G005278
1
2
2
3
3
4
4
Figure 51
1.
Blades side to side
3.
Outside cutting edges
2.
Sail area of blade
4.
Measure from the tip of the
blade to the flat surface
here
5. Measure between the outside cutting edges and
the flat surface (Figure 51). If both measurements
are not within 3/16 inch (5 mm), an adjustment is
required; continue with this procedure.
6. Move to the left side of the machine. Loosen, but
do not remove, the rear locking nut on the hanger
bracket (Figure 52).
7. Loosen the side locking nut on the hanger bracket
just enough to allow the eccentric plate to be adjusted
(Figure 52). Use a 3/8 inch drive extension on a
socket wrench to manipulate the eccentric plate. Use
the wrench to reposition the height of the mower
deck and adjust to the desired height.
8. Stop the deck at the adjusted position and tighten the
side locking nut on the hanger bracket to hold the
new position (Figure 52). Tighten the rear locking
nut on the hanger bracket.
9. Continue leveling the deck by checking the
front-to-rear blade slope; refer to Adjusting the
Front-to-Rear Blade Slope.
3
G005074
1
2
3
4
5
6
Figure 52
1.
Hanger bracket
4.
Eccentric adjustment plate
2.
Rear locking nut
5.
Socket wrench hole
3.
Side locking nut
6.
Socket wrench with 3/8
inch extension
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
5/16 inch (7.9 mm) lower than the rear of the mower,
adjust the blade level using the following instructions:
1. Park the machine on a level surface and disengage
the blade control switch.
36
Summary of Contents for TimeCutter Z5035
Page 44: ...Schematics G009744 Electrical Diagram Rev A 44 ...
Page 45: ...Notes 45 ...
Page 46: ...Notes 46 ...
