g017700
2
3
4
5
6
Figure 14
1.
Control panel
4.
Off
2.
Choke control
5.
Run
3.
Ignition key
6.
Start
6. After the engine starts, push down on the Choke
control (Figure 14). If the engine stalls or hesitates,
pull up on the Choke control and let the engine run
for a few seconds. Then push down on the Choke
control. Repeat this as required.
Operating the Blades
The blade control switch, represented by a power
take-off (PTO) symbol, engages and disengages power
to the mower blades. This switch controls power to any
attachments that draw power from the engine, including
the mower deck and cutting blades.
Engaging the Blades
Important:
Do not engage the blades when parked
in tall grass. Belt or clutch damage can occur.
1. Release pressure on the motion control levers and
place the machine in neutral.
2. Move the throttle to the Fast position.
Note:
Always engage the blades with the throttle
in the Fast position.
3. Pull up on the blade control switch to move it to the
On position and engage the blades (Figure 15).
Figure 15
1.
Control panel
2.
Blade control switch—On
position
Disengaging the Blades
Push down on the blade control switch to move it to
the Off position and disengage the blades (Figure 16).
Figure 16
1.
Control panel
2.
Blade control switch—Off
Testing the Safety Interlock
System
Test the safety interlock system before you use the
machine each time. If the safety system does not
19
Summary of Contents for TimeCutter MX 4260
