Toro Super Recycler 21681, Operator'S Manual

Page: 17 / 92

Servicing the Air Filter
Service Interval: Yearly
1. Press down on the latch tabs on top of the
air-filter cover (
Figure 23 ).
g011722
Figure 23
1. Latch tabs 3. Foam pre-filter
2. Paper air filter
2. Open the cover.
3. Remove the paper air filter and the foam
pre-filter (
Figure 23 ).
4. Inspect the foam pre-filter, and replace it if it is
damaged or excessively dirty.
5. Inspect the paper air filter.
•
If the air filter is damaged or is wet with oil
or fuel, replace it.
•
If the air filter is dirty, tap it on a hard surface
several times or blow compressed air less
than 207 kPa (30 psi) through the side of the
filter that faces the engine.
Note:
Do not brush the dirt off the filter;
brushing forces dirt into the fibers.
6. Remove the dirt from the air-filter body and the
cover using a moist rag.
Important:
Do not wipe dirt into the air duct.
7. Install the foam pre-filter and the paper air filter
into the air filter.
8. Install the cover.
Changing the Engine Oil
Service Interval: After the first 5 hours
Yearly
Note:
Run the engine a few minutes before changing
the oil to warm it. Warm oil flows better and carries
more contaminants.
Engine Oil Specifications
Engine oil capacity 0.55 L (18.6 fl oz)
Oil viscosity SAE 30 or SAE 10W-30
detergent oil
API service classification SJ or higher
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page 15) .
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out (
Figure 24 ).
g235096
Figure 24
4. Tip the machine onto its side (so that the air
filter is up) to drain the used oil from the oil-fill
tube (
Figure 24 ).
16