Toro Super Recycler 21681, Operator'S Manual

Page: 10 / 92

g007284
Figure 12
1. Handle lock 2. Handle positions
Adjusting the Cutting
Height
Adjust the cutting height as desired. Set all the
cutting-height levers to the same height. To raise and
lower the machine, refer to
Figure 13 .
g012130
Figure 13
1. Cutting-height lever
Important:
The cutting height settings are 25 mm
(1 inch); 38 mm (1-1/2 inch); 51 mm (2 inches); 64
mm (2-1/2 inches); 83 mm (3-1/4 inches); 95 mm
(3-3/4 inches); 108 mm (4-1/4 inches).
During Operation
During Operation Safety
General Safety
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
The blade is sharp; contacting the blade can result
in serious personal injury. Shut off the engine and
wait for all moving parts to stop before leaving the
operating position.
•
When you release the blade-control bar, the
engine should shut off and the blade should stop
within 3 seconds. If not, stop using your machine
immediately and contact an Authorized Service
Dealer.
•
Keep bystanders out of the operating area. Keep
small children out of the operating area and under
the watchful care of a responsible adult who is
not operating the machine. Stop the machine if
anyone enters the area.
•
Always look down and behind you before moving
the machine in reverse.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lightning.
•
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Avoid mowing in
wet conditions.
•
Use extreme care when approaching blind
corners, shrubs, trees, or other objects that may
block your view.
•
Do not direct the discharge material toward
anyone. Avoid discharging material against a wall
or obstruction; material may ricochet toward you.
Stop the blade(s) when crossing gravel surfaces.
•
Watch for holes, ruts, bumps, rocks, or other
hidden objects. Uneven terrain could cause you
to lose your balance or footing.
•
If the machine strikes an object or starts to
vibrate, immediately shut off the engine, wait for
all moving parts to stop, and disconnect the wire
from the spark plug before examining the machine
9