Toro Super Recycler 20382, Operator'S Manual

Page: 6 / 72

decal131-0894
131-0894
Traction Adjustment
1. Attention; read the Operator's Manual —1) Loosen the
knob by turning it counter clockwise; 2) Pull the cable(s)
away from the engine to decrease the traction, or push
the cable(s) toward the engine to increase the traction; 3)
Tighten the knob by turning it clockwise.
decal131-4514b
131–4514
1. Warning—read the Operator's Manual .
2. Cutting/dismemberment hazard of hand or foot, mower
blade—stay away from moving parts; keep all guards and
shields in place.
3. Cutting/dismemberment hazard of hand or foot, mower
blade—disconnect the spark-plug wire and read the
instructions before servicing or performing maintenance.
4. Thrown object hazard—keep bystanders a safe distance
from the machine; stop the engine before leaving the
operating position; pick up any debris before mowing.
5. Cutting/dismemberment hazard of hand or foot, mower
blade—do not operate up and down slopes; operate side to
side on slopes; look behind you when backing up.
Setup
1
Assembling and Unfolding
the Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle
improperly can damage the cables, causing
an unsafe operating condition.
• Do not damage the cables when
assembling and unfolding the handle.
• Ensure that the cables are routed to the
outside of the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Raise the rear of the machine housing to its
highest cutting-height setting by moving the 2
rear cutting-height levers all the way forward.
Refer to
Adjusting the Cutting Height (page 10) .
2. Attach the handle ends to the machine housing
with 2 washers and 2 handle bolts (
Figure 3 ),
but do not tighten the handle bolts.
g017457
Figure 3
1. Washer 3. Handle end
2. Handle bolt
Important:
Route the cables to the outside
of the handle ( Figure 3 ).
3. Rotate the handle rearward ( Figure 4 ).
5