g020547
Figure 6
1.
Lift arm number
2 = 38.1 cm
(15 inches)
2.
Lift arm number 3 =
45 degrees
5.
On lift arm number 6 and number 7, position
the brackets and U-bolts 36.8 cm (14.5 inches)
behind the center line of the pivot knuckle
(
).
Note:
Rotate the brackets 10 degrees to the
outboard side of the machine.
g020548
Figure 7
1.
Lift arm number
6 = 36.8 cm
(14.5 inches)
2.
Lift arm number 7 =
10 degrees
6.
Tighten all the U-bolt nuts to 52 to 65 N∙m (38
to 48 ft-lb).
7.
Mount a lift chain to each chain bracket with a
screw, a washer, and a nut, positioning them as
shown in
.
g006540
Figure 8
1.
Lift chain
2.
Chain bracket
Using the Kickstand
Whenever the cutting unit has to be tipped to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand to make sure that the nuts on the
back end of the bedbar adjusting screws are not
resting on the work surface (
g003318
Figure 9
1.
Kickstand
14
