Toro reelmaster 3550 series, Installation Instructions Manual

Page: 3 / 16

Installing the Weights
Install the weights to the cutting units as shown in
Figure 4 .
g283859
Figure 4
1. Carriage bolts (5/16 x 1
inch)
3. Weight
2. Flange nuts (5/16 inch),
torque to 20 to 26 N∙m (15
to 19 ft-lb)
Installing the Roller-Brush
Assembly
1. Remove the 2 flange locknuts securing each
roller bracket to the side plates,
as well as any
6 mm (1/4 inch) spacers positioned on the
top side of the side-plate mounting flange
( Figure 3 ).
Note:
Do not remove the bolts. Keep the flange
locknuts for future assembly.
2. Position the left or right roller-brush-assembly
mounting brackets onto the roller-bracket bolts
(
Figure 5 ).
g033296
Figure 5
1. Left roller-brush assembly
2. Roller-brush mounting
bracket
Important:
Attach the mounting brackets
for the roller-brush assembly directly to
the top surface of the side-plate mounting
flange of the cutting unit.
Do not put spacers
3