Toro reelmaster 3550 series, Installation Instructions Manual

Page: 2 / 16

Determining the
Roller-Brush Orientation
All cutting units are shipped with the counterweight
mounted to the left end of the cutting unit. Refer to
Figure 1 to determine the position of the roller brush
and reel motors.
g027187
Figure 1
1. Cutting unit 1 5. Cutting unit 5
2. Cutting unit 2 6. Reel motor
3. Cutting unit 3 7. Right roller-brush drive
assembly
4. Cutting unit 4 8. Left roller-brush drive
assembly
Note:
These instructions and illustrations show the
installation of the kit on cutting units with the universal
groomer mounted on the left end of the cutting unit.
Installing the Kit
Installing the Grease Fitting
1. Remove the grease fitting for the roller from the
side of the cutting unit that has the roller-brush
housing (
Figure 3 ).
g032170
Figure 2
1. Grease fitting
2. Install the 90-degree grease fitting so that it
faces rearward (
Figure 2 ).
g032171
Figure 3
1. 6 mm (1/4 inch) spacer 3. 90-degree grease fitting
2. Side-plate mounting flange 4. Flange locknuts (remove)
2