Toro reelmaster 3550 series, Installation Instructions Manual

Page: 6 / 16

Installing the Drive Pulley
1. Restrain the reel before installing the drive
pulley; refer to
Restraining the Reel for Installing
Threaded Inserts (page 13) .
2. Install the drive pulley onto the groomer shaft
(
Figure 11 ).
g033204
Figure 11
1. Drive pulley 2. Hex-drive bolt—torque to
20 to 26 N∙m (15 to 19
ft-lb)
3. Apply 242 Loctite (blue) to the hex-drive bolt
and use the bolt to secure the pulley to the
driveshaft; refer to
Figure 11 .
Note:
Torque the bolt to 20 to 26 N∙m (15 to
19 ft-lb) .
Important:
If you do not properly torque the
bolt, the bolt will come loose.
Installing the Belt
1. Install the belt onto the pulleys as follows:
•
Loop the belt around the drive pulley and
then over the top of the idler pulley ( Figure
12 ).
g033205
Figure 12
1. Drive pulley 3. Belt
2. Idler-pulley assembly 4. Driven pulley
•
Start the belt on the driven pulley ( Figure
13 ).
•
Use a 9/16-inch deep-well socket to rotate
the brush assembly and guide the belt onto
the driven pulley (
Figure 13 ).
g033206
Figure 13
1. Belt 2. 9/16-inch deep-well socket
Important:
Ensure that the ribs on the belt
are properly seated in the grooves in each
pulley and that the belt is in the center of the
idler pulley.
6