Toro Reelmaster 33455, Operator'S Manual

Page: 24 / 28

10. Reinstall the hub caps.
Replacing the Lift-Arm
Bushing
1. Position lift arm in the down position.
2. Remove the cutting unit.
3. Remove the nut from the end of the pin ( Figure
36 ).
g012778
Figure 36
1. Lift arm 4. Capscrew
2. Nut 5. Link
3. Pin assembly
4. Remove the capscrew from the pin assembly.
5. Remove the link between the hydraulic cylinder
and the lift arm.
6. Remove the pin assembly.
7. Remove the bushings in the lift arm.
8. Insert and size the new bushings and replace
the pin.
9. Replace the capscrew and nut.
10. Install the link.
11. Grease the bushing with Mobilux #2 grease or
equivalent.
Important:
It may be necessary to drive the
pin assembly out of the lift arm. Be careful
not to damage the threads.
24