Toro Reelmaster 03485, Operator'S Manual

Page: 18 / 24

g034113
Figure 27
1. Bedknife (vertical) 2. Angle indicator
2. Press the Alt Zero button on the angle indicator.
3. Place the angle-indicator mount on the edge of
the bedknife so that the edge of the magnet is
mated with the edge of the bedknife (
Figure 28 ).
Note:
The digital display should be visible from
the same side during this step as it was in step 1 .
g034114
Figure 28
1. Angle-indicator mount 3. Bedknife
2. Edge of the magnet mated
with the edge of the
bedknife 4. Angle indicator
4. Place the angle indicator on the mount as shown
in
Figure 28 .
Note:
This is the angle that your grinder
produces, and should be within 2 degrees of the
recommended top grind angle.
Servicing the Bedbar
Removing the Bedbar
1. Turn the bedbar-adjusting screws
counterclockwise to back the bedknife
away from the reel (
Figure 29 ).
g027175
Figure 29
1. Bedbar-adjusting screw 3. Washer
2. Bedbar 4. Spring-tension nut
2. Back out the spring-tension nut until the washer
is no longer tensioned against the bedbar
(
Figure 29 ).
3. On each side of the machine, loosen the locknut
securing the bedbar bolt (
Figure 30 ).
g003334
Figure 30
1. Bedbar bolt 2. Locknut
4. Remove each bedbar bolt allowing the bedbar
to be pulled downward and removed from the
machine bolt (
Figure 30 ).
Note:
Account for 2 nylon washers and 1
stamped steel washer on each end of the bedbar
(
Figure 31 ).
18