Toro ProLine 30441, Operator'S Manual, Page: 29 / 64

29
1
2
3
4
4
m–6510
Figure 27
1. Center Gage Wheels and
Spacer
2. Nut
3. Bolt
4. Washer
Adjusting the Handle Height
The handle position can be adjusted to match the
operator ’s height preference.
1. Remove the hairpin cotter pin and clevis pin from the
drive lever and neutral lock (Fig. 28).
m–6639
6
5
3
7
2
4
1
Figure 28
1. Left handle shown
2. Neutral lock
3. Clevis pin
4. Drive lever
5. Control rod
6. Operator Presence
Control lever (OPC)
7. Hairpin cotter
2. Loosen the nuts holding the swivel connected to the
speed control crank (Fig. 29).
1
2
3
3
m–7582
Figure 29
1. Speed control rod
2. Swivel
3. Nut
3. Loosen the upper flange bolts (3/8 x 1–1/4 inch) and
flange nut securing handle to rear frame (Fig. 30).
4. Remove the lower flange bolts (3/8 x 1 inch) and
flange nuts securing handle to rear frame (Fig. 30).
5. Pivot handle to desired operating position and install
lower flange bolts (3/8 x 1 inch) and flange nuts into
mounting holes. Tighten all flange bolts.
m–6600
7
8
9
2
1
3
5
6
4
Figure 30
1. Handle assembly
2. Rear frame
3. Flange nut, 3/8 inch
4. Lower flange bolt, 3/8 x
1 inch
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
9. Upper flange bolt, 3/8 x
1–1/4 inch
6. Adjust the swivel on the speed control rod and tighten
the nuts against the swivel (Fig. 29).
7. Adjust the control rod length by rotating the control
rod in the rod fitting (Fig. 29).