Toro ProLine 30441, Operator'S Manual, Page: 16 / 64

16
Step
2
Installing the Handle Assembly
Parts needed for this step:
Qty. Part
1
Handle assembly
2
Flanged bolt, 3/8 x 1 inch
2
Flanged bolt, 3/8 x 1–1/4 inch
4
Flange nut, 3/8 inch
Procedure
1. Align handle with upper mounting holes in rear frame
(Fig. 4).
2. Secure the handle at each upper mounting hole with a
flange bolt (3/8 x 1–1/4 inch) and flange nut (Fig. 4).
3. Select the low position for the lower mounting hole
(Fig. 4).
4. Secure the handle at each lower mounting hole with a
flange bolt (3/8 x 1 inch) and flange nut (Fig. 4).
Note: The handle position can be adjusted to match the
operator ’s height preference.
m–6600
7
8
9
2
1
3
5
6
4
Figure 4
1. Handle assembly
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
9. Flange bolt, 3/8 x
1–1/4 inch
Note: Handle assembly must be installed before fuel tank
is installed.