24
1. After adjusting height-of-cut, check the gage wheels so
that there is a minimum of 3/8 inch (10 mm) clearance
above the ground (Figures 21, 22, and 23).
2. If adjustment is needed, remove the bolt, washer(s)
and nut (Figures 21, 22, and 23).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Figures 21, 22, and 23).
4. Install the bolt, washer(s) and nut (Figures 21, 22,
and 23).
1
3
m–6471
2
Figure 21
1.
Gage wheel
2.
Nut
3.
Washer
m–6470
2
4
3
5
1
Figure 22
1.
Gage wheel
2.
Nut
3.
Bolt
4.
Washer
5.
Spacer
1
2
3
4
4
m–6510
Figure 23
1.
Center Gage Wheels and
Spacer
2.
Nut
3.
Bolt
4.
Washer
Adjusting the Handle Height
The handle position can be adjusted to match the
operator ’s height preference.
1. Remove hairpin cotter, washer and clevis pin securing
control rod fitting to idler bracket (Fig. 24).
1
3
4
4
2
m–5316
Figure 24
1.
Control rod
2.
Rod fitting
3.
Idler bracket
4.
Clevis pin, washer and
hairpin cotter
2. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Fig. 25).