17
5. Check the parking brake adjustment (Fig. 10). Refer to
Checking the Brakes, page 32.
Note: Make sure brake rod is installed in front (F)
mounting hole in idler bracket.
1
2
m–5233
3
Figure 10
1.
Upper control bar
2.
Parking brake lever
3.
Fixed bar
5
Step
Parts needed for this step:
•
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install unused
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 11).
m-6505
3
2
1
Figure 11
1.
Hairpin cotter
2.
Unused spacers
3.
Height–of–cut post
6
Step
Parts needed for this step:
•
1 Rear weight
•
2 Capscrews
•
2 Washers
•
2 Nuts
Installing the Rear Weight
1. Remove lag screws securing weight to shipping crate.
Remove weight and discard screws.
2. Secure weight to rear of frame with 2 capscrews,
washers and nuts (Fig. 26).
Note: The weight mounted in the rear position is
recommended, except when a Tru–Trak
Sulky is
installed.