![background image](http://html1.mh-extra.com/html/toro/proline-30259/proline-30259_operators-manual_1133862035.webp)
35
MEASURE FROM
CUTTING EDGE TO A
LEVEL SURFACE
m–2539
Figure 53
Changing the Deck
Front-to-Rear Pitch
Changing the front–to–rear pitch is done by adjusting the
front height–of–cut posts.
Changing the Deck Front–to–Rear Pitch
by Adjusting Front Height–of–Cut Posts
1. To change the front-to-rear pitch, the front
height–of–cut posts can be adjusted (Fig. 54).
2. To raise the front of the deck, loosen jam nut and
rotate the front pin clockwise (Fig. 54).
3. To lower the front of the deck, loosen jam nut and
rotate the front pin counter clockwise (Fig. 54).
3
m–5231
1
2
4
5
Figure 54
1.
Caster Wheel
2.
Carrier Frame
3.
Front height–of–cut pins
4.
Jam nut
5.
Ball joint
4. Position the blades front-to-rear (Fig. 52). Measure at
C and D locations (Fig. 52) from a level surface to the
cutting edge of the blades (Fig. 53).
5. Check the side-to-side leveling of the cutting unit.
Checking the Deck
Side-to-Side Level
1. Check the tire pressure on both deck and traction unit.
2. Position the blades side-to-side (Fig. 55). Measure at A
and B locations (Fig. 55) from a level surface to the
cutting edge of blade tips (Fig. 56).
3. The difference between measurements A and B should
be no more than 1/4 in. (6 mm).
A
Front
B
m–1078
Figure 55
MEASURE FROM
CUTTING EDGE TO
A LEVEL SURFACE
m–2550
Figure 56
Changing the Side-to-Side
Level
Changing the side–to–side leveling is done by adjusting
tire pressure.
Changing the Side–to–Side Level with
Tire Pressure
1. Change the tire pressure on both deck and traction
unit. Do this to the corresponding side that needs
adjustment.
2. Recheck the front-to-rear pitch and side to side
leveling of the cutting unit.
Matching Height of Cut
1. Check the tire pressure on both deck and traction unit.
Summary of Contents for ProLine 30259
