Toro ProLine 20 HP, Operator'S Manual

Page: 15 / 48

Assembly
13
Install Wheels
1.
Mount wheels to wheel motor hubs with (8) lug nuts
(Fig. 1).
Torque bolts to 55 ft. lbs. (75 N
.
m).
m–2634
Figure 1
1. Wheel
2. Hub
3. Lug nut
Install Upper Handle
1. Align upper handle with mounting holes in rear
frame (Fig. 2). Select high, medium or low
position for lower mounting hole.
2. Secure each side with (2) 3/8–16 x 1” (26mm)
flange bolts and flange nuts (Fig. 2). Torque
bolts to 25 ft. lbs. (34 N.m).
m–3063
Figure 2
1. Upper handle
2. Rear frame
3. Flange bolt 3/8–16 x 1”
(26mm)
4. Flange nut 3/8”
Install Control Rods
Before installing and adjusting control rods loosen
quick release levers and move reference control bar
all the way forward.
Left Control Rod
1. Slide clevis pin through rod fitting and mounting
hole in control bracket (from outside). Secure
with washer and hairpin cotter (Fig. 3).
2. Remove hairpin cotter and rod from upper
control bars.
3. Press and hold upper control bars against
reference bar, so stop hits.
4. Push rod full forward until bearing is against
control bracket stop. Thread rod in or out of
fitting on control bracket until rod aligns with
holes in upper control bars (Fig. 3).
5. When rod and holes in upper control bars line
up, turn rod one (1) additional turn, so rod is
shorter.
Note: Upper control bar stop must hit
reference bar before roller hits control
bracket stop.
6. Connect rod to upper control bars with
previously removed hairpin cotter.