PRELIMINARY – For Toro Distributor
and Toro Company
use only.
ProForce Debris Blower
Page 6
−
3
Chassis
General Information
Operator’s Manual
The Operator’s Manual provides information regarding
the operation, general maintenance and maintenance
intervals for your ProForce Debris Blower. Refer to the
Operator’s Manual for additional information when ser-
vicing the machine.
Securing ProForce Debris Blower to Tow Vehicle
While operating or servicing the ProForce blower, make
sure that hitch pin is properly positioned in tow vehicle
hitch and blower tongue. Hitch pin should be secured
with hairpin clip (Fig. 1).
1. Tow vehicle hitch
2. Hitch
pin
3. Hairpin
clip
Figure 1
3
2
1
Electrical Power
Electrical power to ProForce Debris Blower compo-
nents is controlled by the Remote Control Module. To
make sure that machine operation does not occur unex-
pectedly, disconnect the negative battery cable from the
battery before performing any machine service.
Reattach the disconnected negative battery cable as
the last step in any repair. Secure cable with flange nut.
Torque nut from from
10 to 15 ft
−
lb (14 to 20 N
−
m)
.
