Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
Handle bolts
4
Curved washers
4
1.
Locknuts
4
Install the upper handle.
2.
No parts required
–
Install the wheel clutch cable ends
3.
No parts required
–
Install the traction control linkage.
Carriage bolts
2
4.
Locknuts
2
Install the chute control rod.
5.
Cable ties
2
Connect the wire to the headlight.
6.
No parts required
–
Fill the engine with oil.
7.
No parts required
–
Check the tire pressure.
8.
No parts required
–
Check the skids and scraper.
1. Installing the Upper Handle
Note:
Do not remove the rubber band until you have
installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important:
Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables and the wire for the headlight
are not pinched between the handle sections.
Figure 3
1. Cables
2. Secure the upper handle with 4 handle bolts, 4 curved
washers, and 4 locknuts from the loose parts bag (Figure
4).
6
