8.
Move the speed-selector lever forward and
rearward a few times.
9.
Install the back cover and return the machine to
the operating position.
Adjusting the
Discharge-Chute Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge-chute latch.
1.
Loosen the clamp fastener on the chute-support
plate until the cable is free.
g019021
Figure 35
1.
Cable conduit
3.
Clamp fastener
2.
Cable clamp
2.
Remove any slack in the cable by pulling the
cable conduit rearward.
3.
Tighten the clamp fastener while holding the
cable in place.
Replacing the Drive Belts
If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.
27
