Toro Multi Pro WM 41240, Operator'S Manual

Page: 50 / 84

6. Turn the
AGITATION
switch on.
7. Add the proper amount of chemical concentrate
to the tank, as directed by the chemical
manufacturer.
Important:
If you are using a wettable
powder, mix the powder with a small amount
of water to form a slurry before adding it to
the tank
8. Add the remaining water to the tank.
Note:
For better agitation, decrease the
application rate setting.
Operating the Booms
The
BOOM
-
LIFT
switches on the sprayer control panel
allow you to move the booms between the transport
position and the spray position without leaving the
operator's seat. Change boom positions while the
machine is stationary.
Setting the Hydraulic Lift Lock
Engage the hydraulic lift lever and lock it to provide
hydraulic power for control of the boom lift.
1. Push forward the hydraulic-lift lever ( Figure 70
or Figure 71 ).
g255717
Figure 70
Manual Transmission Workman Vehicles
1. Push forward 3. Hydraulic-lift lock
2. Move left 4. Hydraulic-lift lever
g255716
Figure 71
Automatic Transmission Workman Vehicles
1. Push forward 3. Hydraulic-lift lock
2. Move left 4. Hydraulic-lift lever
2. Move the hydraulic-lift lock left to engage the
lock (
Figure 70 or Figure 71 ).
Changing the Boom Position
1. Stop the sprayer on level ground.
2. Use the
BOOM
-
LIFT
switches to lower the booms.
Note:
Wait until the booms reach the full,
extended spray position.
3. When the booms need to be retracted, stop the
sprayer on level ground.
4. Use the
BOOM
-
LIFT
switches to raise the booms,
until they have moved completely into boom
transport cradle forming the “X” transport
position and the boom cylinders are fully
retracted.
Important:
To prevent damage to the
boom actuator cylinder, make sure that
the actuators are fully retracted before
transporting the machine.
Using the Boom Transport Cradle
The sprayer is equipped with a boom transport cradle
that has a unique safety feature. In the event of
accidental boom contact with a low overhead object
while in the transport position, the boom(s) can be
pushed out of the transport cradles. If this occurs, the
booms will come to rest in a near horizontal position
to the rear of the vehicle. While the booms will not
be damaged due to this movement, they should be
immediately put back into the transport cradle.
Important:
The booms can be damaged by
transporting them in any position other than the
“X” transport position using the boom transport
cradle.
50