Toro Groundsmaster 7210 Series, Operator'S Manual

Page: 47 / 64

g020435
Figure 61
1. Dipstick 2. Oil-fill cap
4. If the oil is below the safe range, remove the
fill cap (
Figure 61 ) and add oil until the level
reaches the Full mark.
Important:
Do not overfill the engine with
oil.
Note:
When using different oil, drain all old oil
from the crankcase before adding new oil.
5. Install the oil-fill cap and dipstick.
6. Close the hood and secure it with the latches.
Crankcase Oil Capacity
5.2 liters (5.5 qt) with the filter.
Changing the Engine Oil And Filter
Service Interval: Every 250 hours
Change the oil and filter every 250 hours.
1. Remove the engine oil drain plug ( Figure 62 )
and let the oil flow into a drain pan. When all the
oil is drained, install the drain plug.
1
2
g021890
g021890
Figure 62
1. Engine oil drain plug 2. Oil filter
2. Remove the oil filter ( Figure 62 ). Apply a light
coat of clean oil to the new filter seal before
screwing it on.
Do not overtighten.
3. Add oil to the crankcase; refer to Checking the
Engine Oil.
Servicing the
Diesel-Oxidation Catalyst
(DOC) and the Soot Filter
Service Interval: Every 6,000 hours or clean the soot
filter if engine faults
SPN
3720
FMI
16,
SPN
3720
FMI
0, or
SPN
3720
FMI
16 display in the InfoCenter.
•
If advisory message
ADVISORY
179 displays in the
InfoCenter, the DPF is nearing the recommended
point for servicing the diesel-oxidation catalyst and
the soot filter.
g213865
Figure 63
•
If engine faults
CHECK ENGINE SPN
3251
FMI
0,
CHECK ENGINE SPN
3720
FMI
0, or
CHECK ENGINE
SPN
3720
FMI
16in the InfoCenter ( Figure 64 )
display in the InfoCenter, clean the soot filter using
the steps that follow:
47